Bandwidth to Support Convergence
Convergence means combining or converging voice, data and video
onto a single network. Enterprises usually need to expand their
LAN bandwidth and set up a QoS or Quality of Service priority
system to give priority to real-time streams such as telephone
calls or video conference feeds, which are more sensitive to network
delays than data transfers. Most often, the common protocol for
convergence is IP.
What is Ethernet over Copper
Ethernet over Copper, or EoC, uses copper transmission lines rather
that fiber optics. T1 lines are most often used to transport mid-band
Ethernet signals in the 1 to 10 Mbps bandwidth range when provisioning
fiber optic lines is too expensive.
Is Ethernet a Full or Half
The original Ethernet implementation was based on avoiding collisions
on packets all sharing the same network line. Small networks using
hubs are half-duplex. Switched Ethernet networks are full duplex
because the layer 2 switches prevent packet collisions.
How does Spanning Tree Protocol
STP or Spanning Tree Protocol is a technique used by Ethernet
switches to ensure that there is one and only one physical path
from source to destination. This is done to prevent forwarding
Will Carriers "Light Buildings"?
Some will if their closest point of presence (POP) is within a
mile or so of your location. The farther away you are, the higher
the bandwidth commitment needs to be in order to justify the carrier's